Soni Incorporation

1. LoRa™ modem 
2. Support FSK, GFSK, MSK, GMSK, LoRa™ and OOK modulation methods.
3. Support frequency band 803MHz~930MHz.  
4. Working voltage is 3.3V, maximum output is +22dBm, maximum working current is 140mA.
5. Low power consumption characteristics in receiving state, the minimum receiving current is 4.2 mA, standby current is 1.6mA.
6. High sensitivity: as low as -140dBm.
7. Small volume dual row stamp hole patch package.
8. The module adopts SPI interface, half-duplex communication, with CRC, up to 256-byte packet engine.

1. With strong anti-interferenceability, can work normally in complex interference environment.
2. Minimum receiving sensitivity 137dBm SF=12/ BW=125KHz
3. Max Tr ansmi t power: +20dBm.
4. Operat e frequency 410MHz ~525MHz  Default
5. The vol t age of power supply input  3. 3V.
6. Transmi t cur rent  107mA  Full load power consumption
7. Recei ve cur rent  6mA.
8. Sleep cur rent  3uA.

1. Adopt SMD-18 package.
2. Support frequency: 803MHz ~930MHz.
3. Working voltage is 3.3V, theoretical maximum transmit power: +22dBm.
4. High sensitivity: -138dBm @125Kz SF12.
5. Support spread spectrum factor: SF5/SF6/SF7/SF8/SF9/SF10/SF11/SF12.
6. Embedded memory, 128KB FLASH,16KB SRAM.
7. Support LoRa/(G)FSK/BPSK/(G)MSK modulation.
8. Antenna interface is compatible with stamp holes / circular holes and IPEX, etc., support more option selection.
9. Support multiple sleep modes: depth sleep current is low to 0.9uA.

1. LoRa™ modem.
2. Support FSK, GFSK, MSK, GMSK, LoRa™ and OOK modulation methods.
3. Support frequency band 410MHz~525MHz.
4. Working voltage is 3.3V, maximum output is +22dBm, maximum working current is 140mA.
5. Low power consumption characteristics in receiving state, the minimum receiving.
6. current is 4.5 mA, standby current is 1.6mA.
7. High sensitivity: as low as -140dBm.
8. Small volume dual row stamp hole patch package.
9. The module adopts SPI interface, half-duplex communication, with CRC, up to 256-byte packet engine.

• Support preamble detection

• Support half-duplex SPI communication

• Programmable bit rate up to 300Kbps

• Support FSK, GFSK, MSK, GMSK, LoRa and OOK modulation modes

• Support automatic RF signal detection, CAD mode and ultra-high speed AFC

• Packets with CRC, up to 256 bytes

• LoRa Spread Spectrum Modulation Technology
• AI thinker LoRa/FSK/00K

1. Can be directly controLled by Tmall Elf without a gateway.
2. 1.6mm pitch pin vertical solder DIP18 or SMD- 13 package.
3. 6 PWM outputs.
4. With on-board antenna, no need to design antenna.
5. Brightness (duty cycle) adjustment range 5% -100%.
6. Factory default 50% duty cycle for cool and warm colors.
7. PWM output power 1KHz.
8. With night light function.
9. With wall switch to switch color temperature function.

• BLE 5.0 module
• Design for Smart Light, Smart Plug and Smart Power Strip Application
• 1.6mm pitch pin vertical solder DIP18 or SMD- 13 package
• 6 PWM outputs
• With on-board antenna, no need to design antenna
• Brightness (duty cycle) adjustment range 5% -100%
• Factory default 50% duty cycle for cool and warm colors
• PWM output power 1KHz
• Can be directly controlled by Tmall Elf without a gateway
• 1.6mm pitch pin vertical solder DIP18 package
• 6 PWM outputs With on-board antenna, no need to design antenna
• Brightness (duty cycle) adjustment range 5% -100%
• Factory default 50% duty cycle for cool and warm colors
• PWM output power 1KHz
• With night light function
• With wall switch to switch color temperature function

1. 1. 1mm spaci ng SMD-20 package.
2. 6 PWM out put.
3. antenna patch pad, reserved antenna hole can be directly inserted spring antenna.
4. brightness (duty cycle) adjustment range 5- 100%.
5. factory default warm and cool color duty cycle 50% each.
6. PMW out put frequency 1 KHz.
7. with small night light function.
8. with wall switch switching color temperature functionion.

1. Can be di rectl y controlled by Tmall Elf without a gateway.
2. SMD-22 package.
3. 6 PWM outputs.
4. With on-board antenna, no need to design antenna.
5. Brightness (duty cycle) adjustment range 5% -100%.
6. Factory default 50% duty cycle for cool and warm colors.
7. PWM output frequency 1KHz.
8. Support multiple sleep modes, deep sleep current as low as 0.4uA. With wall switch to switch color temperature function.
9. Support secondary development.

• LoRa spread spectrum modulation technology

• Receive sensitivity as low as -141 dBm

• Support preamble detection

• Support half-duplex SPI communication

• Programmable bit rate up to 300Kbps

• Support FSK, GFSK, MSK, GMSK, LoRa and OOK modulation modes

• Support automatic RF signal detection, CAD mode and ultra-high speed AFC

• Packets with CRC, up to 256 bytes

• Interface: SPI

• AI thinker LoRa/FSK/00K

• LoRa  spread spectrum modulation technology 
• Receive sensitivity as low as -141 dBm 
• Excellent resistance to blocking 
• Supports preamble detection 
• Supports half-duplex SPI communication 
• Programmable bit rate up to 300Kbps 
• Supports FSK, GFSK, MSK, GMSK, LoRa  and OOK modulation modes 
• Supports automatic RF signal detection, CAD mode and ultra high speed AFC 
• Packets with CRC, up to 256 bytes

1. 1.1 mm spacing SMD-20 package.
2. 6 channels PWM output.
3. The antenna adopts PCB onboard antenna; at the same time, half hole pad and antenna hole are reserved. The half-hole pad can guide the antenna to the motherboard, and the antenna hole can be directly welded to the spring antenna.
4. Brightness (duty cycle) adjustment range 5%-100%.
5. Factory default cool and warm color 50%.
6. PWM output frequency 1KHz.
7. Features with Nightlight.
8. Switching Color Temperature with Wall Switching.

1. 1.1 mm spacing SMD-20 package.
2. 6 channels PWM output.
3. The antenna adopts half-hole pad mode, which can lead to the main board.
4. With the reservation of antenna holes,for inserted the spring antenna directly.
5. Brightness (duty cycle) adjustment range 5%-100%.
6. Factory default cool and warm color 50%.
7. PWM output frequency 1KHz.
8. Features with Nightlight.
9. Switching Color Temperature with Wall Switching.

1. With strong anti-interferenceability, can work normally in complex interference environment.
2. Minimum receiving sensitivity 137dBm SF=12/ BW=125KHz).
3. Max Transmit power: +21dBm.
4. Operat e frequency 803MHz ~930MHz  Default).
5. The vol t age of power suppl y input  3. 3V.
6. Transmi t cur rent  107mA ???Ful l load power consumption
7. Recei ve cur rent  6mA.
8. Sl eep cur rent  3uA.

1. Support WiFi 802.11b/g/ N, 1T1R mode data rate up to 150Mbps.
2. Support Bluetooth5, Bluetooth Mesh, speed support: 125Kbps, 500Kbps, 1Mbps, 2Mbps.
3. Xtensa-R32-bit LX7 dual-core processor, supports clock frequency up to 240 MHz, has.
4. 512 KB SRAM, 384 KB ROM, and 16KB RTC SRAM 
5. Support UART/GPIO/ADC/PWM/I2C/I2S/SPI/LCD/DVP/RMT/SDIO/USB OTG USB Serial/MCPWM/DMA controller/TWAI controller interface, temperature sensor, pulse counter, capacitive sensors GPIOThe package is SMD-42
6. Integration WiFi MAC/BB/RF/PA/LNA/Bluebooth
7. Multiple sleep modes are supported and the deep sleep current is less than 8uA
8. The serial port rate is up to 5Mbps
9. Supports STA/AP/STA+AP and hybrid modes
10. Smart Config (APP) /AirKiss (wechat) is supported
11. Support serial port local upgrade and remote firmware upgrade (FOTA)
12. Fixed universal AT instruction for quick use
13. Support secondary development, integrated Windows, Linux development environment
14. About Flash: the esp-s3-12k module has 8MByte Flash built-in by default

Soni Incorporation is a trusted name in the embedded electronics industry, serving as a reliable supplier and authorized distributor of advanced connectivity solutions. We specialize in:

• Microcontrollers – Offering a range of powerful, low-power, and high-performance microcontroller units (MCUs) tailored for automation, control systems, and embedded applications.

• WiFi Modules – Delivering seamless wireless connectivity with certified WiFi modules, including popular SoCs for IoT, smart home, and industrial networking solutions.

• Wireless Transceivers – Providing robust long-range communication modules such as LoRa, GSM, GPS, and BLE to support a wide array of wireless communication needs.

At Soni Incorporation, we ensure timely delivery, competitive pricing, and technical support to empower developers, manufacturers, and system integrators across India.